FL-STrider
Roughing it smoothly
- Joined
- Feb 14, 2005
- Messages
- 124
- Age
- 63
- Location
- New Port Richey, Florida
- Bike
- 2004 ST1300
- STOC #
- 5946
Just had all 4 rear bearings, seals and 0-rings replaced by my Honda Dealer. I discovered like so many others that my flange bearings were toast during a tire change. The new flange side bearing spin easily when I place my finger in the center however this is NOT true for the Disc Brake side bearing. It takes considerable effort to spin it and I'm wondering if this is normal? It's really snug an now I'm thinking I need to bring the wheel back to them. When I place the axle in the bearing I can spin it easier and the bearing is smoth and quiet ...again it's just snug. Any ideaa??? Normal ?
Last edited: