Hello,
I purchased the ST2 brake module which powers on your brake lights upon decelerating. The instructions require that you mount the module level in the direction of the label attached to the module. There are 3 wires that need to be connected to the module, black to ground, grey to brake light signal wire, and red/violet to power or to any ignition switched powered source.
Since my 2006 ST1300 has 2 brake light bulbs, there are 2 sets of the wires (and different wire colors than the instructions show). I was told that further down the wiring harness the 2 sets of wires are spliced to a single set of wires, which is where I need to place the included splice connectors to allow the module to be connected to.
Has anyone installed the ST2 brake module on their ST1300, and if so, where did you connect the leads (if possible include pictures).
I am excited to install this component since I constantly downshift to slow down which poses a safety issue since I don't always press on the brake to allow drivers behind me to see that I am slowing down or stopping.
Thanks
I purchased the ST2 brake module which powers on your brake lights upon decelerating. The instructions require that you mount the module level in the direction of the label attached to the module. There are 3 wires that need to be connected to the module, black to ground, grey to brake light signal wire, and red/violet to power or to any ignition switched powered source.
Since my 2006 ST1300 has 2 brake light bulbs, there are 2 sets of the wires (and different wire colors than the instructions show). I was told that further down the wiring harness the 2 sets of wires are spliced to a single set of wires, which is where I need to place the included splice connectors to allow the module to be connected to.
Has anyone installed the ST2 brake module on their ST1300, and if so, where did you connect the leads (if possible include pictures).
I am excited to install this component since I constantly downshift to slow down which poses a safety issue since I don't always press on the brake to allow drivers behind me to see that I am slowing down or stopping.
Thanks