Here is my seat review of the Terry Adcox Seat in pdf format.
You can download and read.
Hope you enjoy...
You can download and read.
Hope you enjoy...
Last edited:
Terry Adcox Seat for 2014 Yamaha FJR1300A
- Thread starter Red-On-Rockwell
- Start date
the Ferret
Daily rider since May 1965
Hey I just read this somewhere else lol
Nashcat
Site Supporter
I’ll second the good review for Terry and his seat building. I have two of his seats, one on the V-Strom and one on the new Wing. He’s close enough to ride over and get custom fitted, while sitting on the bike.
Ride Safe
John
Ride Safe
John
okckeith
Site Supporter
That sure is a good looking BMW in that picture! 
Glad you got it worked out for you. I still need to send mine to him.
Glad you got it worked out for you. I still need to send mine to him.
Nashcat, what's the cost of the custom fitted wing seat? I didn't see that option on his website.
I've always used Russell, but Shasta Lake CA is too far for a custom fit. Honestly, the 08 Wing seat is pretty good and doesn't need much.
I've always used Russell, but Shasta Lake CA is too far for a custom fit. Honestly, the 08 Wing seat is pretty good and doesn't need much.
Nashcat
Site Supporter
Mine was $300 for what he calls a “single bucket”. Only the front section is shaped, but the entire seat is recovered. SinceTerry rides the previous version Wing, he’s familiar with any work you would need. All of his seats are custom fitted, usually from pictures, sent in with the order, but if you ride down to his shop, Terry will take the pictures he needs as well as looking at your seating position.
John