Reginald
cyclepoke
I haven't been able to clear the error code from the throttle body sync and vacuum hose repairs I made a while ago. Can someone tell me what I'm doing wrong?
I'm using a paper clip to cause the short between the brown and green/orange wires in the data link connector.
1) Short wires with paper clip
2) turn ignition key on
3) F1 light stops blinking and remains on
4) remove shorting wire
5) short wires again. I've held the short for about 15 secs and the light will not go off and start blinking again.
Previously I have tried turning the engine off with the kill switch an then turn key off. I've been told this resets the ECM. Hasn't worked for me.
FYI the error code is the map sensor that had the vacuum hoses removed during the throttle body sync.
Could really use some help here. Don't want to ride around with that thing blinking.
I'm using a paper clip to cause the short between the brown and green/orange wires in the data link connector.
1) Short wires with paper clip
2) turn ignition key on
3) F1 light stops blinking and remains on
4) remove shorting wire
5) short wires again. I've held the short for about 15 secs and the light will not go off and start blinking again.
Previously I have tried turning the engine off with the kill switch an then turn key off. I've been told this resets the ECM. Hasn't worked for me.
FYI the error code is the map sensor that had the vacuum hoses removed during the throttle body sync.
Could really use some help here. Don't want to ride around with that thing blinking.