OK,
i have (almost) completed install of a set of dual beam LED driving lights that have a flood and beam combo (essentially High and Low beam settings).
I have them running through a relay for the high/low function and need to tie it into the same circuit as the High/Low on the bike....(use the high on the switch to trigger the relay) and I left my manual home.
Which wire do I tie into to get this function? I see references to a high beam headlight relay ...(?) but apparently my searching skills are a bit rough as I am finding it hard to actually figure out which one it is!
can anyone provide details on what I am looking for?
I am a complete amateur at this so please be gentle!
oh yeah ... 2012 ST1300a
Thanks,
Scott
i have (almost) completed install of a set of dual beam LED driving lights that have a flood and beam combo (essentially High and Low beam settings).
I have them running through a relay for the high/low function and need to tie it into the same circuit as the High/Low on the bike....(use the high on the switch to trigger the relay) and I left my manual home.
Which wire do I tie into to get this function? I see references to a high beam headlight relay ...(?) but apparently my searching skills are a bit rough as I am finding it hard to actually figure out which one it is!
can anyone provide details on what I am looking for?
I am a complete amateur at this so please be gentle!
oh yeah ... 2012 ST1300a
Thanks,
Scott