I've elected to change oil in my forks. and the left cap unscrewed without any real effort. the right not so much. I put both tubes back into the triple tree and tightened the pinch bolts..still the cap will not budge! i',ve gone as far as to cut a 1.5" length of 17mm allen wrench , insert it and then slip a box wrench over it( extended with a 12" section of pipe)...then turn(yes the right direction) while striking the allen section on top with a ballpeen hammer. still no joy. my Clymer manual says that these are assembled , using chemical thread loc. so I also tried heat, and penetrating oil too. outwardly the cap flange looks to be sitting on the tube, just as one would expect..and the same as the other tube is( the one that offered no resistance) anyone have some insight as to how to get this cap moving?