For those of you who've stalled aftermarket springs (sonic 1.2) when you cut your PVC pipe, what length did you use, and did you use the factory thin washer on top of the PVC, or allow the PVC to slip up into the cap? Will it hurt anything if the spacer is up inside the cap? I was wondering if being "trapped" by the center of the cap would cause any binding? With the stock set up the spacer sits directly on the edge of the for cap. I tried using the set up recommended by sonic (washer between spring and PVC spacer, then oem washer on top of spacer) and I am getting a lot of mechanical noise, which I suspect is the washer slipping back and forth on the spacer and coming in contact with the sidewalls of the fork tube.
Comments or suggestion?
Comments or suggestion?