@Willsmotorcycle, I think in your picture of the left side of the bike there is a mistake. You show an arrow pointing to a connector next to the big plastic boot covered connector in the harness. I don't think that is the OEM quartet harness 9 pin connector. The Q-harness 9 pin is dangling near the left fork leg's triple clamp. IIRC, the factory wiring for this was not long enough to reach the boot covered 20+ pin connector.
Anyone ever install a quad-lock hard wired charging head?
- Thread starter GhenghisKen
- Start date
- Joined
- Oct 26, 2020
- Messages
- 503
- Location
- Makefield Highlands PA
- Bike
- 2016 ST1300P
- 2026 Miles
- 004565
You are correct sir, that is a picture that does not have a quartet installed.