I read the tutorial on doing the sync and I feel comfortable doing it on my own. My question is about resetting the ECM after syncing the throttle bodies. Is this necessary and what is it accomplishing? This is the only thing in the tutorial that seemed a bit unclear to me so I would greatly appreciate any comments regarding the subject.
My ST is experiencing a bit of a rough idle on a cold start when the air temperature is warm (75+), it wanders a bit right away then eventually settles down. When at full operating temp the bike idles smooth at 1000 RPM and on a cold start at a lower air temp it goes to the normal high idle until it heats up to one bar then drops to idle smoothly at the correct RPM. If anyone has any suggestions based on these symptoms I would also appreciate them as I am just assuming it just needs a sync at 75,000 miles.
Thanks,
kflan
My ST is experiencing a bit of a rough idle on a cold start when the air temperature is warm (75+), it wanders a bit right away then eventually settles down. When at full operating temp the bike idles smooth at 1000 RPM and on a cold start at a lower air temp it goes to the normal high idle until it heats up to one bar then drops to idle smoothly at the correct RPM. If anyone has any suggestions based on these symptoms I would also appreciate them as I am just assuming it just needs a sync at 75,000 miles.
Thanks,
kflan