For Sale 2010 Front Calipers, SMC, hoses etc. Vacuum Sealed since 2011

[Grand Rouge]

These parts were removed from a low mile...less than 500 miles and less than two months after dealer purchase. Reason was that the ST was to be converted to a trike...or a side car affair. Wheels, complete front end, brakes included were remove

The calipers and the SMC delay valve etc. were flushed with fresh brake fluid / assembly fluid and vacuum packed same day.

All parts appear and feel as new. I removed a caliper piston recently....perfect and looks as if just removed from a HONDA labeled bag.

Brake parts are complete...brake pads excluded.... Pins and anti rattle hardware etc...all there and all hoses...flex and the steel lines that connect just above fender...all there and perfect.

Complete package $350.00 delivered lower 48.

 

[Grand Rouge]

Pics ... Freshly removed from vac storage. These parts fit 2008 and newer....................

 

[Grand Rouge]

BUMP. And:

Looking at Parts catalogues Kiosks etc..... It would appear that the 2008 and later ST1300 brake parts can be swapped onto the 2003 / 2007 years.

The hose and hard line attachments and part numbers aere same across all years. The parts that I have listed above are a complete front end brake assembly right up to where brake lines disappear under the fairing. Minus Pads.

Just putting this out there. If others have info..pro or not or...? glad to learn DRR

 

[Igofar]

I think you throwing out some misinformation there!
the 03-07 model years have a smaller size caliper, shorter pad hanging pins, and more fasteners, and shorter pads, just to mention a few things.
Yes, some of the pieces like bleed nipples, and hoses, may be the same, but yours are NOT interchangeable with earlier models.
From 08 and up, Honda uses a sandcast one piece body, longer pins, and longer pads.
This is why the pads are not interchangeable between these years.

 

[Grand Rouge]

I think you throwing out some misinformation there!
the 03-07 model years have a smaller size caliper, shorter pad hanging pins, and more fasteners, and shorter pads, just to mention a few things.
Yes, some of the pieces like bleed nipples, and hoses, may be the same, but yours are NOT interchangeable with earlier models.
From 08 and up, Honda uses a sandcast one piece body, longer pins, and longer pads.
This is why the pads are not interchangeable between these years.

Igofar... Don't insult me. Are you referring to post #3? Who said anything about interchangeable PADS between pre and post 2008 models? My 'thought' was that the entire system...calipers and hoses and brackets and SMC and delay valve...all of it..as shown in the pics...appear to be 'connectable' (hoses) with the hydraulics basically just out of sight under the fairing.

Pads...of course the early pads do not fit in the later calipers.... I said BRAKE PARTS. NO MENTION OF BRAKE PAD INTERCHANGABILITY.