28 amp alternator removal help

ok after the welding, things skrew up , due to the welding heat, the internal bearing gave away, the alternator does spin freely, look like i need to replace the bearing
IMG_20131203_182222.jpg IMG_20131203_183201.jpg
 
Last edited:
anybody know how to remove this bearing IMG_20131203_183222.jpgthis is the rear small bearing facing the back cover
 
Last edited:
Counter clockwise to remove the left swingarm pivot bolt lockring.

Only one of your attachments in posts 22-24 is showing up, and clicking on them results in a dead link... :(
 
Last edited:
kawamewa said:
anybody know how to remove this bearing this is the rear small bearing facing the back cover
Click to expand...
A small bearing-puller, 2- or 3-legged:

bearing-pullers-16269-4238201.jpg Garage_Tool_Bearing_Puller.jpg

When installing the new bearing on the shaft, ensure to put force only onto the inner race.
Clean and lube the shaft end, find a fitting socket or pipe and a small hammer to tap that inner bearing race on.
 
ST1100Y said:
A small bearing-puller, 2- or 3-legged:

View attachment 146476 View attachment 146477

When installing the new bearing on the shaft, ensure to put force only onto the inner race.
Clean and lube the shaft end, find a fitting socket or pipe and a small hammer to tap that inner bearing race on.
Click to expand...

thanks ST1100Y, will look for the tools and try do my self, worse case i'll send to machine shop
 
You must log in or register to reply here.
Top Bottom