Hi All
Well MOT time is a few weeks away so knew I needed to change the fork oil and seals.
The problem im having is the bolt at the bottom of the fork housing ie the one that screws into the damper rod, I cracked it off as it says in the manual, but the bolt will not separate from the damper rod, ive tried putting the fork back together and put pressure on it but no joy.
Any advice?
Also I had to cut the front mudguard/fender bolts off as they were solid, I will buy some stainless nuts, bolts and washers and make the little spacers etc...
The fork oil was knackered and had a nice creamy grey look to it, so don't think it had been done recently.
Cheers
Chris
Well MOT time is a few weeks away so knew I needed to change the fork oil and seals.
The problem im having is the bolt at the bottom of the fork housing ie the one that screws into the damper rod, I cracked it off as it says in the manual, but the bolt will not separate from the damper rod, ive tried putting the fork back together and put pressure on it but no joy.
Any advice?
Also I had to cut the front mudguard/fender bolts off as they were solid, I will buy some stainless nuts, bolts and washers and make the little spacers etc...
The fork oil was knackered and had a nice creamy grey look to it, so don't think it had been done recently.
Cheers
Chris