HealTech ST1300 diagnostic tool?

[Mellow]

Anyone have any experience with this?

HealTech Honda ST1300 Pan European 08-15 OnBoard Diagnostic Tool

Purchase the HealTech Honda ST1300 Pan European 08-15 OnBoard Diagnostic Tool from SportbikeTrackGear.com. Get the lowest price, free shipping deal, easy exchanges and no restocking fees - Guaranteed!

www.sportbiketrackgear.com

 

[Obo]

Found a video from 2015 that it won't do DCT codes, not that the ST's have DCT. The model does more than just ST1300's, Hondas or bikes.

 

[Mellow]

LOL.. if it did detect an error it would say 'not found'

I downloaded the software and it does show a lot of parameters, but figuring out what is baseline and what isn't and if it results in some solution is another question... plus, only works on 08 and newer ST1300s.

 

[wizel]

I have the Healteach software.
Here is a picture of my ST1300 in idle mode-no errors.
You would have to disconnect a connector, for example the knock sensor, to see what error it shows. I haven't done that yet, too bad.
Have also this month no more time to do so, 2 large moped meetings are pending.
Once 4 days and once the large annual meeting of the Flyingbrickforums of 7 days.
I am then the only ST rider among about 100 K75 / K100 / K1100 and K1200 BMW drivers.
greetings from germany
holm

 

[Al st1100]

LOL.. if it did detect an error it would say 'not found'

I downloaded the software and it does show a lot of parameters, but figuring out what is baseline and what isn't and if it results in some solution is another question... plus, only works on 08 and newer ST1300s.

I don't know what info it gives. Does it have fuel trim % ? That woud be first thing I would look for, LT ( long term) ST ( short term). Those numbers should be in the range of +5 , -5 hot or closed loop. Baro should be your barometric pressure, AIT, air intake temp hotter than ouside air. Map, look at key on engine off VS engine running. should see a change of about 3-4 volts. Sometimes it's not easy to diag just by data. Easier with a code then look at data.