HealTech ST1300 diagnostic tool?

Found a video from 2015 that it won't do DCT codes, not that the ST's have DCT. The model does more than just ST1300's, Hondas or bikes.

 
LOL.. if it did detect an error it would say 'not found' :rofl1:

I downloaded the software and it does show a lot of parameters, but figuring out what is baseline and what isn't and if it results in some solution is another question... plus, only works on 08 and newer ST1300s.
 
  • Like
Reactions: Obo
I have the Healteach software.
Here is a picture of my ST1300 in idle mode-no errors.
You would have to disconnect a connector, for example the knock sensor, to see what error it shows. I haven't done that yet, too bad.
Have also this month no more time to do so, 2 large moped meetings are pending.
Once 4 days and once the large annual meeting of the Flyingbrickforums of 7 days.
I am then the only ST rider among about 100 K75 / K100 / K1100 and K1200 BMW drivers.
greetings from germany
holm
 

Attachments

  • healtech.jpg
    healtech.jpg
    107.8 KB · Views: 18
Mellow said:
LOL.. if it did detect an error it would say 'not found' :rofl1:

I downloaded the software and it does show a lot of parameters, but figuring out what is baseline and what isn't and if it results in some solution is another question... plus, only works on 08 and newer ST1300s.
Click to expand...
I don't know what info it gives. Does it have fuel trim % ? That woud be first thing I would look for, LT ( long term) ST ( short term). Those numbers should be in the range of +5 , -5 hot or closed loop. Baro should be your barometric pressure, AIT, air intake temp hotter than ouside air. Map, look at key on engine off VS engine running. should see a change of about 3-4 volts. Sometimes it's not easy to diag just by data. Easier with a code then look at data.
 
You must log in or register to reply here.
Back
Top Bottom