st11ray
2006 ST1300
I need help! I'm replacing my rear brake pads and can't get the caliper back on the rotor. I took the wheel off and pulled the old pads out. Cleaned the pistons and pushed them all the way back in. But, when I install the new pads, I am not even close to getting the rotor to line up. I've got all kinds of room between the pads. I even put EBC's in instead of the OEM's I have because the EBC's are a little thinner. I also put the wheel and caliper on with just the outside pad in and then tried to put the inside pad in. I'm off by the entire thickness of the pad surface. What am I doing wrong? I have the service manual and I've had my rear wheel on and off many times before.
Please HELP, it's driving me nuts!
Please HELP, it's driving me nuts!