I Need Your Input on Where to Put In a Gerbing Heating Controller

Joined
Sep 5, 2013
Messages
8
Location
Northeast Illinois
Bike
1994 ST1100
I have a Gerbing Permanent Dual-Zone Controller installed on my 1994 ST1100 that I'm hoping to transfer over to the ST1300 I'll be picking up next week. I had the control knobs and LEDs placed in the flat of the left cowl pocket piece panel. It was the perfect location since it was just out of my peripheral vision, right where my my left hand would fall, and easy to have the wiring reach from within. Not having had the chance to study the 1300's body panels, I'm not sure if there is a similar spot available. Could anyone clue me in to what options exist so I can plan ahead? i want to get this done asap once I get the bike as I intend to ride through the winter.



Thanks in advance!
 
I would suggest the left cowl pocket cover again but it is the locking panel. You might need to lock something in there one day and I would think the controller would take up space. Maybe the right cover? Kinda clumsy to use though.
 
I considered mounting my Heat Troller there, but didn't want to drill holes for something I don't use year round.
On the GSA, I stuck a small piece of hook and loop / velcro on a body panel, and the lanyard is secured by a body panel screw.
The zipper on my tankbag keeps it secure above the map pocket on the 1300, with the lanyard looped through the zipper pull.
Without a tankbag, I would again use the velcro, with a longer lanyard as needed.
The finger shows where I would use velcro.
 

Attachments

  • 20261117_062645.jpg
    20261117_062645.jpg
    233.5 KB · Views: 12
Last edited:
Back
Top Bottom