Measurements need of shock ends

[Coosacounty]

Hello everyone I’m needing some measurements of the shock ends and was wondering if anyone had their old shock laying around that would measure it for me. The reason is, I own a Kawasaki Vulcan 2000 and was trying to buy a progressive RAP shock but they are not making them anymore and everwhere I called there out of stock. So after hours of digging around I found out that the Vulcan and st1300 share almost identical measurements and looking at online pictures have the same looking ends. Progressive will not give the measurements out so I turned to y’all for help. If possible I need the bolt diameter too.

vulcan in yellow and st1300 in blue

 

[W0QNX]

Top, your outside, the rubber bushing sleeve is 28.32mm wide and has a 10mm bolt.

Bottom, your inside, is 39.37 wide and takes a 10mm bolt. It's also 20.83 from saddle bottom to bolt side (saddle depth). that would be 25.83 to bolt centerline.

 

[Coosacounty]

Top, your outside, the rubber bushing sleeve is 28.32mm wide and has a 10mm bolt.

Bottom, your inside, is 39.37 wide and takes a 10mm bolt. It's also 20.83 from saddle bottom to bolt side (saddle depth). that would be 25.83 to bolt centerline.

Perfect just what I was looking for