Rebuilding front of ST1300AE 2014

Joined
Apr 5, 2014
Messages
1
Location
Turriff
Hi All


I have a 2014 registered ST1300, recently I had an off which smashed the windscreen, both mirrors, windscreen motor,
I have now purchased all the parts I need for the rebuild and have started to do just that,
I need a bit of advice, Please
I managed to slip the headlight unit out without to much of an issue but my issue is getting it back in,
Am I doing something wrong ?? If so what is it
Do I need to release both side fairing parts to slide it in, never showed that in the utub£ video I watched about 20 times to make sure I would be doing it right but it will not slide in, feels like I need 3 hands.
Can Anyone help
 
Someone will be along today, I'm sure. There is a bit of a time difference between the two sides of the pond.

I never pulled my headlight assy out of my bike, but I always pulled the fairing pieces off to do any work at all - front cowl pieces around the forks as well as the two big side pieces (middle cowls). Removing the middle cowls (not sure if that is necessary) will give you a good look at the front subframe that holds the instrument panel, wind screen assembly, etc.
 
Yes, the middle fairing need to be moved out of the way to get the headlight into place.

As for your getoff, how bad was it. Two areas you need to look at is the upper cowl stay. They can get bent.

DSC00376.JPG

Also, if the bike went down on it's side, the tipover bars will bend, where they attach to the aluminum triangle.

Tipoverbars-bad-good.jpg

When those parts are bent, the body parts will not line up properly and it puts stress on the connections, causing cracking.

Good luck!
 
Back
Top Bottom