Rubber Coating For Tire Machine Grabbers

[vstrom.zrxdude]

These like the ones I posted above are basically the same. I put them on the bottom side of the rim and then clamp the claws on the protectors. Mine only has three clamps so I use three. Yours probably has four claws so you would need four. I have a manual machine but have used mine on an air/electric machine too.

I apologize if I don't understand how your machine works.

I have no idea what SupraSabre is doing to them I've had the same ones for years and they are tough as nails.

Clamp from my old Coats 220

Same changer@protector setup I use

 

[Uncle Phil]

Just a note - those I got from Amazon fit my Atlas machine, stay in place, and do what they need to do.
I've done 4 tire changes with then (2 fronts, 2 rears) and I am very happy with them.
Thanks again @CruSTy