RobbieAG
Robert
I just finished my winter maintenance. I started with an oil change (which in hindsight was a mistake). I also replaced the coolant, brake and clutch fluid, fork oil, rear pads, plugs, radiator cap, and checked the valves. I was surprised to find all of the exhaust valves, and one intake valve out of spec. I went ahead and adjusted them. The manual calls for a mix of 50/50 moly grease and motor oil for the cam lobes, bearings, and gears during reassembly. My question is, if it was your bike, would you change the oil again due to the moly grease in there? I'm leaning towards changing it, though I'd rather not if I don't have to. Thanks in advance.
Last edited: