I see that Uni-go has a hitch with an accessory receiver attachment. How much weight can the ST1300 really support? I have a Pakit Rak that I used with my Goldwing Bushtec receiver, will the ST1300 handle that weight hanging off of the back end?
ST1300 Hitch Weight/Cargo Capacity
- Thread starter jjenkins334
- Start date
Looking again at the Uni-go page, I may have misinterpreted the receiver attachment. It looks like it takes an existing receiver and converts it to Uni-go, instead of the other way around. Does anyone have experience with the Uni-go hitch that can verify?
Darn it, back to looking for a solution for my Pakit Rak!
Darn it, back to looking for a solution for my Pakit Rak!
Yeah, the unigo hitch isn't a reciever hitch design like many offered for the wing.
Most, if not all, hitches for ST11/ST13 are to simply get a hitch ball back there and not designed for the square vertical tubing as a receiver.
You might be able to make one or maybe someone here can... Here's one @KTD1911 did and looks like there would be room to weld or bolt on a square vertical receiver so the pakit rack would slide into..
Most, if not all, hitches for ST11/ST13 are to simply get a hitch ball back there and not designed for the square vertical tubing as a receiver.
You might be able to make one or maybe someone here can... Here's one @KTD1911 did and looks like there would be room to weld or bolt on a square vertical receiver so the pakit rack would slide into..
rulbe
Site Supporter
This is the Uni-go hitch I took off my ST that I just sold this summer. It uses a plate that you could put a ball on. I can't find the Uni-go plate, but I may have it somewhere.
