Hey guys, read a LOT if not all of the info on here that I could find about doing the deed.. New to ME '05 ST1300 w 58K miles, no idea if it has ever been done so going to give it a shot. To keep it as brief and painful as possible, I thought it would be good to have all the tools./parts I need before diving in. Considering getting a shim kit off fleabay so can have all various sizes on hand if needed, some rtv/sealent stuff, specail tool from the shop manual (going to make that). What I DONT know (it is a long list) is what kind of gaskets, O rings, washers, ect. I might need to have on hand to replace during the job. Valve cover gasket sounds like it is reusable but what about anything else needing replaced while I am in there? Any advice kindly appreciated. Newbs.... I know...
Previous bike and previous forum I was one of the old guys... now I'm starting all over again!??! =)
Previous bike and previous forum I was one of the old guys... now I'm starting all over again!??! =)