Ok, broke the ’06 ST1300 out for a ride on a spring feeling day after setting for a month. Felt like it was following the ruts on my gravel road too much so returned for a tire pressure check. Up to this point all was well with the abs light. Rear was a few pounds low so aired up and started again. Instead of light going out after self check it went to constant flash mode. Pulled ABS motor fuses, key on, 5 sec., put one fuse back in, solid red light, no code flashes. Tried a few more times, different fuse sequences, cleaned wheel sensors of dust, disconnected battery, same result.
Any suggestions appreciated! Thanks!
Any suggestions appreciated! Thanks!