New under mirror light brackets

skipcurt

skipcurt

Skip
Joined
May 23, 2009
Messages
746
Location
Woodstock, GA
Bike
'18 BMW R1200 GSA
I have another thread here about my current under mirror light brackets not working. I've been working with ST11Ray on getting his old Dick Seng brackets remanufactured. The attached photos are of ST11Rays brackets. I spoke with the machine shop today about mass producing these for those who are in need of under mirror brackets.

Please reply here if you are interested in a set. I do not have a cost yet until I get him a number to manufacture and decide if they will be aluminum or steel. They will be machined in either material so they will look nice but they will not be coated. Unfortunately he does not do powder coating so if it's steel you will have decide on your own finish and the same if it's aluminum but you could leave that raw.

I'm not looking to create a business here or make any money from this product. I'm just offering because I am getting a set made and I know the struggle with getting a good under mirror light bracket now that the originals creators are defunct.

Skip
 

Attachments

  • 1.jpg
    1.jpg
    80.1 KB · Views: 152
  • 2.jpg
    2.jpg
    87.4 KB · Views: 152
I will gather the rough numbers until 2/10/19. I will talk with the shop on 2/11 and gather some numbers and hopefully post back the same day. We'll take it from there.
 
If these will work with more than a single light model, I'm in for a pair. They will fit the ST1100, right?
 
Just to clarify. These are for the 1300. They will be made out of aluminum. I will get a price tomorrow. As of today I am ordering 5 sets. Please respond if you want a set.
 
2 aluminum brackets with 1 stainless socket cap screw will be $80 shipped for 5 sets or 10 brackets.

Please confirm your interest to purchase ASAP.

Skip
 
All the same dimensions except extending the lower arm that the light hangs from 1" and of course moving the outer hole the 1" also. This replicates the longer MCL bracket.
 
We are extending the mounting arm 1" to allow the use of 5" lights. 5" lights will touch the fairing using the original Dick Seng mounts.
I had to drill the mounting plate on my 5" lights to shift them out enough to clear my fairing with my Dick Seng mounts. I still only clear it by 1/4" and have to remove my lights in order to remove my fairing. Hopefully moving the mounting hole out an inch will give enough clearance to remove the fairing without removing the lights.
 
You must log in or register to reply here.
Back
Top Bottom