1st clutch & brake bleed advice needed
Printed out cheat sheet.
Got out mityvac hand pump. Clutch went well, nice firm lever.
Started on front brakes, put teflon tape on upper bleeder. Master cylinder went dry while I had bleeder out. : Bled both front upper bleeders in seq. Still nothing at lever!!
Now I'm getting frustrated.
So I decide to move on and tilt smc and bleed pcv. Got nice clean fluid through it.(with help from pedal)
Did front bleeder on rear caliper. Then I thought I hope I don't have to do this again, since I don't have anything at lever.
So my question is should I stop where I'm at and start over from the beginning?
Or go through with complete seq and then start on front?
Printed out cheat sheet.
Got out mityvac hand pump. Clutch went well, nice firm lever.
Started on front brakes, put teflon tape on upper bleeder. Master cylinder went dry while I had bleeder out. : Bled both front upper bleeders in seq. Still nothing at lever!!
Now I'm getting frustrated.
So I decide to move on and tilt smc and bleed pcv. Got nice clean fluid through it.(with help from pedal)
Did front bleeder on rear caliper. Then I thought I hope I don't have to do this again, since I don't have anything at lever.
So my question is should I stop where I'm at and start over from the beginning?
Or go through with complete seq and then start on front?