I bought a used Wilbers shock , with the compression tank on flexible hose . Two adjustment screws on the tank. Tell me I did good . Any one have suggestion to where to mount the tank ? Or a photo. I hadn't thought about that . Thanks !
Wilbers rear shock
- Thread starter JJames
- Start date
Uncle Phil
Site Supporter
I run Wilbers on all of my ST1100s but I do not have the 'remote' stuff ones since my riding weight stays the same.
Good piece of kit for sure and places to have them rebuilt if necessary.
Could the tank fit in the tailpiece?
Good piece of kit for sure and places to have them rebuilt if necessary.
Could the tank fit in the tailpiece?
Uncle Phil
Site Supporter
Won't quite work for a ST1100 unless you wanted to cut a hole in the side panel.
STFlips
Site Supporter
PM Kiltman, pretty sure he has one on the 11
Mine is a Hagon, I just have a remote and it’s attached to the grab rail,
the Ferret
Daily rider since May 1965
The 23 NC 750X I just bought came with a Wilbers 3-way adjustable rear shock. I never thought I was a complete idiot until I tried dialing this thing in.
OP
OP
JJames
Site Supporter
Well , thats not going to happen. Might be a spot behind the right panel or grab rail. It dosen't have a hand adjuster knob , just the red and blue sett screws. Will just have to see, when it gets here.
Uncle Phil
Site Supporter
@sirepair (he has a Hagon with an adjuster on his ST1100P) mounted his adjuster on the grab rail IIRC.